Altium
Moderátor: Moderátoři
https://ibb.co/vHjVRmY
No... vytvořil jsem teda projekt, přesunul tam ten výkres, ale v souboru s deskou stále nic.
![Shocked 8O](./images/smilies/icon_eek.gif)
No... vytvořil jsem teda projekt, přesunul tam ten výkres, ale v souboru s deskou stále nic.
![Shocked 8O](./images/smilies/icon_eek.gif)
Oni to zas nejak zmenili, parchanti, vlez do toho project a daj tam Validate, píšu že prebehne kompilácia.
EDIT:
Takže najprv Validate, potom Update pcb
....z návodu k AD22:
Access
With a source document for the project open as the active document, this command is accessed by choosing the Project » Validate Project command, from the main menus.
Use
After launching the command, the Compiler will check for logical, electrical, and drafting errors between the Dynamic Data Model (DDM) and compiler settings in the active project. Any violations that are detected by the Compiler will be listed as warnings and/or errors in the Messages panel.
EDIT:
Takže najprv Validate, potom Update pcb
....z návodu k AD22:
Access
With a source document for the project open as the active document, this command is accessed by choosing the Project » Validate Project command, from the main menus.
Use
After launching the command, the Compiler will check for logical, electrical, and drafting errors between the Dynamic Data Model (DDM) and compiler settings in the active project. Any violations that are detected by the Compiler will be listed as warnings and/or errors in the Messages panel.
Dal sem teda Validate.
No... a musím vyřešit ty Errory, počítám, aby mě to pustilo dále, že?
Jak je vyřeším?
https://ibb.co/rkyTpSk
No... a musím vyřešit ty Errory, počítám, aby mě to pustilo dále, že?
Jak je vyřeším?
https://ibb.co/rkyTpSk
Tak, dal jsem Validate - tentokrát to proběhlo bez errorů - ale stále nemám ty součástky v prostoru na návrh PCB. ![Confused :?](./images/smilies/icon_confused.gif)
https://ibb.co/j5fJbyk
![Confused :?](./images/smilies/icon_confused.gif)
https://ibb.co/j5fJbyk
OK, dal jsem Validate, potom Update - https://ibb.co/mH19XWV - a pořád nic.mihal píše:mihal píše: ...Takže najprv Validate, potom Update pcb...